This technique does not require you to heat-up the sticker in anyway. You just need to separate one side of the sticker from the case (note: the entire sticker does not need to be removed). This tech is incredibly simple, just requiring patience and a little work. The blowdryer + razor tech didn’t work for me, but many have said it did work for them. Maybe a combination of both methods would work best.

You can now send your xbox 360 in for repairs if ever in need. Microsoft’s servicing department hasn’t been known to do this, but they could perform a ultraviolet light check and see that one side of the sticker has been removed. I don’t think this will constitute warranty voidance or become standard practice, but use at own risk.

Sticker Removal Instructions

“When you have the face plate and the side vents off Just lever the 1st clip (on the left) a little while pushing the case apart slightly, so the clip stays open, working your way from left to right towards the seal do each clip the same. When you get to the clips closest to the seals try and get them both open while the seal is still attached, a little levering should do the trick Then just gently lift the case by the seal while at the same time pulling it apart and you will find the seal gives way to the pressure and one end always slides off intact leaving the whole sticker in tip top condition. by Whirlers

Works every time for me, just takes a little practice.